phone: +39-011-988 2251 fax: +39-011-988 1358 http://gpsemi.it/pdf/GPTR5230.pdf GPTR5230 phase controlled scr high reliability operation dc power supply controlled rectifiers dc drives - motor starters blocking voltage up to 4400 v average current 2300 a surge current 37 ka blocking characteristics characteristic conditions v rrm repetitive peak reverse voltage 4400 v v rsm non-repetitive peak reverse voltage 4500 v v drm repetitive peak off-state voltage 4400 v i drm repetitive peak off-state current, max. v drm , single phase, half wave, tj = tjmax 300 ma i rrm repetitive peak reverse current, max. v rrm , single phase, half wave, tj = tjmax 300 ma on-state characteristics i t(av) average on-state current sine wave,180 conduction, th = 55 c 2300 a i t(rms) r.m.s. on-state current sine wave,180 conduction, th = 55 c 3613 a i tsm surge on-state current non rep. half sine wave, 50 hz, v r = 0 v, t j = t jmax 37 ka i2t i2 t for fusing coordination 6845 ka2s v t(to) threshold voltage t j = t jmax 1.20 v r t on-state slope resistance t j = t jmax 0.300 m w v tm peak on-state voltage, max on-state current i t = 3000 a , tj = tjmax 2.10 v i h holding current, max t j = 25 c 300 ma i l latching current, typ t j = 25 c 1500 ma triggering characteristics v gt gate trigger voltage t j = 25 c, v d = 12 v 3 v i gt gate trigger current t j = 25 c, v d = 12 v 300 ma v gd non-trigger voltage v d = 67% v rrm , t j = t jmax 0.35 v p gm peak gate power dissipation pulse width 0.5 ms 150 w p g(av) average gate power dissipation 5 w i fgm peak gate current 10 a v fgm peak gate voltage (forward) 30 v v rgm peak gate voltage (reverse) 5 v switching characteristics di/dt critical rate of rise of on-state current t j = t jmax 200 a/s dv/dt critical rate of rise of off-state voltage t j = t jmax 1000 v/s t q turn-off time, typ t j = t jmax , i t = 2300 a, di/dt = -10 a/s 630 s vr = 100 v, vd = 67% vdrm, dv/dt = 50 v/s thermal and mechanical characteristics r th(j-c) thermal resistance (junction to case) double side cooled 0.009 c/w r th(c-h) thermal resistance (case to heatsink) double side cooled 0.002 c/w t jmax max operating junction temperature 125 c t stg storage temperature -40 / 125 c f clamping force 10% 45 kn mass 1500 g document GPTR5230t002 value green power solutions srl web: www.gpsemi.it e - mail: info@gpsemi.it
phase controlled scr GPTR5230 ordering information GPTR5230-vvgl vv : blocking voltage / 100 (e.g. 44 for 4400 v) g : trigger lead type ( s = straight t = twisted blank = no leads) l : trigger lead lenght x 100mm ( 3 - 4 - 5 - 7 blank = no leads) document GPTR5230t002 0 500 1000 1500 2000 2500 3000 3500 4000 4500 5000 0 1 2 3 i t [a] v t [v] on - state voltage drop t j =t jmax 0 1000 2000 3000 4000 1 1.2 1.4 1.6 1.8 2 2.2 2.4 2.6 i t [a] v t [v] on - state voltage drop t j =t jmax 0 5 10 15 20 25 30 35 40 1 10 100 i tsm [a] number of cycle current pulses [n] maximum surge current d.s. cooled 0 0.001 0.002 0.003 0.004 0.005 0.006 0.007 0.008 0.009 0.001 0.01 0.1 1 10 100 z th(j - c) [ c / w] time [s] thermal impedance (j - c) i n the interest of product improvement green power solutions reserves the right to change any specification given in this data sh eet without notice. 50 60 70 80 90 100 110 120 130 0 400 800 1200 1600 2000 2400 heatsink temperature [ c] i t [a] current rating - sine wave 180 90 120 60 30 0 1000 2000 3000 4000 5000 6000 7000 0 400 800 1200 1600 2000 2400 p f [w] i t [a] power loss - sine wave 180 120 90 60 30 dimensions mm
|
